Made on
Tilda
Side splitters for Mazda Axela BM 13-19.
ABS plastic material.
The parts are installed on 3M double-sided tape with a width of 20 mm. Thoroughly clean and degrease the surfaces to be glued, apply an adhesion enhancer for car films and glue a strip of double-sided tape to the splitters. Next, make 2 mm holes in the splitters in specially marked recesses. After this, position the splitter exactly under the side skirts you can tighten it with a screw jack. The next step is to make holes in the plastic sill plugs through the holes in the splitter. Next, remove the protective layer from the double-sided tape, carefully pull the splitters to the side skirt through the screws and firmly press the gluing points. Self-tapping screws will not only act as a safety element, but will also help to glue the splitter evenly to the side skirt, as if along guides. No adhesive tape or adhesion promoter included.
These splitters are suitable only for the type of side skirts that are shown in the product card